Printed Circuit Board Design Professional Surface-mounting and Through-hole soldering Technology: Printed Circuit Board

» » Printed Circuit Board Design Professional Surface-mounting and Through-hole soldering Technology

printed circuit board design which has an inside diameter that I found would just fit over the eyepiece of the microscope for eyepiece projection

printed circuit board design I adjusted the back-focus adjustment on the two cameras so they will focus at the same distance. I used a camera lens and infinity focus on an object

printed circuit board design The output on the Sync Box is connected to a DVD recorder and monitor. 3D shutter glasses are connected to the input provided on the Sync Box

printed circuit board design One camera must be capable of using external sync, so that the scan lines of the two cameras are in sync

printed circuit board design High density interconnected board placement technology capacity High Standard SMT&Solder Assembly Line

 

Gallery of Printed Circuit Board Design Professional Surface-mounting and Through-hole soldering Technology

Printed Circuit Board Design While Observing The Monitor The Switch On The Side Of The Sync Box Is Set To Correct The Picture For The Left And Right EyePrinted Circuit Board Design Various Connectors Can Be Provided According To Your Drawing And Requirement Samples Can Be Provided For Customer If NeededPrinted Circuit Board Design The External Sync Of  One Camera Is Connected To The Video Output Of The Other Camera Through The Use Of A T Connector And A Short CablePrinted Circuit Board Design High Density Interconnected Board Placement Technology Capacity High Standard SMT&Solder Assembly LinePrinted Circuit Board Design One Camera Must Be Capable Of Using External Sync, So That The Scan Lines Of The Two Cameras Are In SyncPrinted Circuit Board Design The Two Cameras Are Connected To The Microscope Using A Telescope Adapters The ScopeTronix C Mount For Video CamerasPrinted Circuit Board Design The Video Output Of Each Camera Is Then Connected To The 3D Video Sync Box Constructed HerePrinted Circuit Board Design I Used A 5mm CS To C Mount Adapter Between The ScopeTronix Adapter And The Video Camera. One Source For This Is SpyTown.  A Rubber Band Was PlacedPrinted Circuit Board Design The Output On The Sync Box Is Connected To A DVD Recorder And Monitor. 3D Shutter Glasses Are Connected To The Input Provided On The Sync BoxPrinted Circuit Board Design I Adjusted The Back Focus Adjustment On The Two Cameras So They Will Focus At The Same Distance. I Used A Camera Lens And Infinity Focus On An ObjectPrinted Circuit Board Design The Video Cameras I Used For This Project Were A Sanyo VCC 3972 Which Is Capable Of  Using External Sync And A Sanyo VCC 6574APrinted Circuit Board Design Which Has An Inside Diameter That I Found Would Just Fit Over The Eyepiece Of The Microscope For Eyepiece Projection
90/100 by 10875 users

About Us

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

© 2018 Replicasuper.Com. Reproduction without explicit permission is prohibited. All Rights Reserved.